Excercise 1 (DE1): from points to lines (24min+10min Tips&Tricks) Empfehlen Extract curves from 3d objects: menue/curve/curveFromObject: Silhouette, extract wireframe…DE1 Rhino excercises "Digitales Entwerfen" Close/open videochapter open lightbox close lightbox Autostop for next chapter on/off prev-chapter play/pause next-chapter -15 +15 0.250.50.7511.251.51.752 Introduction0:0 min Basic setup: Units cm, grid 1 (3)cm0:15 min Excercise 0: variations of how to draw the grid (10 x 10 x10 cm!) Close/open videochapter open lightbox close lightbox Autostop for next chapter on/off prev-chapter play/pause next-chapter -15 +15 0.250.50.7511.251.51.752 Drawing point in absolute mode to the origin: 3,01:22 min Drawing point in relative mode to the selected object: @3,02:13 min Drawing in distance and direction with “SmartTrack”3:08 min CMD “Copy” line of points in Y and Z direction4:0 min Use CMD “array” instead to do everything in one go;-)6:18 min Create layer for points and add points to layer.6:59 min Change layer color for better orientation and swith of basic grid with CMD “Grid”.8:36 min Save file on a regular basis with different filenames (…01, 02, 03) and setup Autosave.9:50 min Excercise 1: from points to lines Close/open videochapter open lightbox close lightbox Autostop for next chapter on/off prev-chapter play/pause next-chapter -15 +15 0.250.50.7511.251.51.752 Create new layer for your design and set layer to active. Extrude line out of point with “Gumball”. Join and explode line.10:39 min Draw polyline with more segments. You can´t join closed lines!13:06 min CMD Undo drawing lines.14:38 min Switch of Point layers for better orientation.15:27 min Change from rigid curve to freeform curve with CMD “ChangeDegree”. Degree 1 = rigid, Degree < 1 = freeform curve.17:12 min Draw control point curve with degree > 1.18:05 min CMD Mirror curves.19:03 min “Menue Solid/Pipe” to give curve thickness (radius).20:15 min Rendering: Change viewport to rendering. Capture viewport and save file.21:49 min 3d printing: save as .STL or .OBJ file.23:36 min Tips & Tricks for excercise 1 Close/open videochapter open lightbox close lightbox Autostop for next chapter on/off prev-chapter play/pause next-chapter -15 +15 0.250.50.7511.251.51.752 CMD “Fillet”, CMD “FilletCorners”: Fillet sharp corners for better results (pipe/Sweep/3d printing)0:0 min Lock Layer with control points!2:21 min CMD “changeDegree”: change degree of curve to create more control points for design.2:45 min Fix mistakes/issues with pipe or curve (delete and renew segments of pipe).3:20 min CMD “Sweep1”: use different/several section for 3d section of your curve. “Orient perpendicular to curce” to adjust section shape to rail. Be aware of Flip direction!5:16 min Fixing issues with 3 curves meeting in one point with PIPE Close/open videochapter open lightbox close lightbox Autostop for next chapter on/off prev-chapter play/pause next-chapter -15 +15 0.250.50.7511.251.51.752 Best solution: 3 none joined and filleted curces. Add sphere with Snap: Center + Narrow0:0 min Leave a Reply Cancel replyYou must be logged in to post a comment.