Disassemble with Grashopper Empfehlen Close/open videochapter By playing this video, you load content from youtube. Please accept youtube in your privacy settings. Change privacy settings Installation componend “Disassemble”0:0 min Einstellungen Rhinofile: Units + Tolerance0:43 min 3d-Objekt: “Triangulate mesh” und “weld vertices”2:0 min Grashopper: Input mesh3:11 min Grashopper: extrude Amount (Number slider-Negativwert) (Wert muss negativ sein!)4:02 min Grashopper: Result (Brep + Bake auf eigenen Layer)5:49 min Grashopper: gap Amount (Number slider)6:30 min Grashopper: Cleanout corners (Boolean Toggle true)7:30 min Grashopper: bugfixing und Lerncurve…9:59 min Rhino: Check Intersection12:31 min Rhino: Problem Fügungen für das Fräsen13:39 min Leave a Reply Cancel replyYou must be logged in to post a comment.
