Set camera views and clipping plane for rendering in Rhino 6 Empfehlen Close/open videochapter By playing this video, you load content from youtube. Please accept youtube in your privacy settings. Change privacy settings Introduction: any viewport is a hidden camera0:0 min CMD “Camera”: switch camera of your selected viewport on with “Show”.0:53 min Adjust camera: move different camera points to navigate camera: position, tilt, target, filed of view.1:39 min Save camera view: set view/”named views”. Show window in navigation bar.2:33 min Parallel and perspective view3:50 min Visualisation: Show save frame and aspect ratio for visualisation.5:9 min Precise position of camera: “orient camera to surface” + “place camera and target”. USe helper points or lines to adjust camera properly.7:34 min By playing this video, you load content from youtube. Please accept youtube in your privacy settings. Change privacy settings Camera position on eye-level for human beeings: +/- 1.60m Navigate with moving targetpoint and view point.9:47 min Field view of human beeing for interior design: focus lens length 15-25mm11:19 min Clipping plane to cut/slice objects/buildings for better orientation.12:27 min Leave a Reply Cancel replyYou must be logged in to post a comment.